二维位置灵敏探测器输出图像畸变的修正

高分辨(e,2e)谱仪采用二维位置灵敏探测器同时对能量和角度进行多道测量.二维位置灵敏探测器由级联使用的微通道板和电阻阳极板组成,由于电阻阳极板的边缘效应和制造工艺的缺陷,测量得到的位置图像与实际图像总会有一定的形变,存在一定的非线性.本文针对高分辨(e,2e)谱仪二维位置灵敏探测器输出图像的“桶形”畸变及位置非线性,采用一种简易的冷刻法(用脉冲信号来模拟真实电子束团),检验了二维位置灵敏探测器的Gear型电阻阳极板的线性好坏,并用分割成小三角形的方法找出测量得到的畸变图像与原始真实图像的映射关系,再用此关系对其它测量得到的畸变图像进行修正,并对修正的结果进行了评估.通过修正,由“桶形”畸变所造成的图像扭曲得到明显改善.修正后的x方向非线性由修正前的2.1%变为0.59%.这种检验和修正方法对其它领域类似探测器输出图像的修正也有一定的指导意义.     

The effects of doubly excited states on ionization balance

The effects of highly doubly excited states on ionization balance are investigated. In the calculation, A Collisional-Radiative model in Detailed-Configuration-Accounting (DCA) is applied to population calculations for NLTE plasmas. Configuration-averaged rate coefficients that needed in the rate equations are obtained based on the first order perturbation theory. The Hatree-Fock-Slater self-consistent-field method is used to calculate the electron wave functions. The mean ionization stage of high-Z plasma Lu is presented. The comparison shows that the mean ionization stage increases more than 3 stages when doubly excited states 5l6l' and 5l5l' are not included in the population calculations.     

共振光散射法测定环境水样中痕量锡

基于在Tris-HCl介质中,痕量锡对氯酚红-人血白蛋白-十二烷基硫酸钠体系的共振散射光谱有明显的猝灭作用;考察了它们的光谱特征、影响因素和适宜的反应条件;确定了散射光强度与Sn2 的关系,从而建立了测定痕量锡的共振光散射新方法.该法在室温下进行,操作方便,灵敏度高和选择性好.其线性范围为0.2-4.0μg/L,检出限0.12μg/L,用于环境水样中痕量Sn2 的测定,相对标准偏差小于3.1%,加标回收率为95.5%-100.5%,效果良好.     

一种用于电光开关的高速、高压电脉冲的产生

介绍了一种用于电光开关驱动源的高压超快电脉冲产生技术；电路采用级联的雪崩晶体管串和微波传输线结构，输出阻抗50Ω；在50Ω负载情况下，获得脉冲下降时间为1ns、幅度达到5kV、峰值电压为6.4 kV、幅度和半宽度稳定性优于2％、触发晃动为±15ps、触发延时为30 ns，脉冲峰值电流为128 A的高压高速大电流脉冲.     

2-(2-喹啉偶氮)-5-二甲氨基苯胺光度法测定铜

在pH=4.0的磷酸盐缓冲介质中,CTMAB存在下,2-(2-喹啉偶氮)-5-二甲氨基苯胺(QADMAA)与铜反应生成2:1稳定络合物,络合物λmax=580nm,ε=1.14×105L·mol-1·cm-1.铜含量在0.01-0.6μg/mL内符合比耳定律,方法用于环境样品中铜的测定,结果令人满意.     

Al-pillared clays supported rare earths and palladium catalysts for deep oxidation of low concentration of benzene

Al-pillared clays supported rare earths (RE/Al-PILC) are prepared and used as supports of palladium catalysts for deep oxidation of low concentrations of benzene (130-160 ppm). The supports and catalysts are characterized by X-ray powder diffraction (XRD), FT-IR, BET, transmission electron microscopy (TEM) and temperature-programmed reduction (H₂-TPR). The results show that Al-pillaring results in a strong increase in the basal spacing (d_0 0 1) from about 1.2 to 1.8 nm, and an increase in the BET surface area from 63.6 (±3.2) to 238.8 (±11.9) m²/g. Activity tests of deep oxidation of low concentration benzene show catalysts supported on Al-PILC and RE/Al-PILC are obviously more active than that on raw clay. Pd/6% Ce/Al-PILC, in particular, can catalyze the complete oxidation of low concentration benzene at a temperature as low as about 290 °C.     

New ligands for the Fe(III)‐mediated reverse atom transfer radical polymerization of methyl methacrylate

A series of (di)picolinic acids and their derivates are investigated as novel complexing tridentate or bidentate ligands in the iron‐mediated reverse atom transfer radical polymerization of methyl methacrylate in N,N‐dimethylformamide at 100 °C with 2,2′‐azobisisobutyrontrile as an initiator. The polymerization rates and polydispersity indices (1.32–1.8) of the resulting polymers are dependent on the structures of the ligands employed. Different iron complexes may be involved in iron‐mediated reverse atom transfer radical polymerization, depending on the type of acid used. ¹H NMR spectroscopy has been used to study the structure of the resulting polymers. Chain‐extension reactions have been performed to further confirm the living nature of this catalytic system. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 2912–2921, 2006     

Surface structures formed by individual adsorption and coadsorption of Mn and Bi on Cu(0 0 1), studied by LEED

We have studied the individual adsorption of Mn and Bi, and their coadsorption on Cu(0 0 1) by low-energy electron diffraction (LEED). For Mn, we have determined the c(2 × 2) structure formed at 300 K, whose structure had been determined by several methods. We reconfirmed by a tensor LEED analysis that it is a substitutional structure and that a previously reported large corrugation (0.30 Å) between substitutional Mn and remaining surface Cu atoms coincides perfectly with the present value. In the individual adsorption of Bi, we have found a c(4 × 2) structure, which is formed by cooling below ∼250 K a surface prepared by Bi deposition of ∼0.25 ML coverage at 300 K where streaky half-order LEED spots appear. The c(4 × 2) structure has been determined by the tensor LEED analysis at 130 K and it is a substitutional structure. In the coadsorption, we found a c(6 × 4) structure, which has been determined by the tensor LEED analysis. It is very similar to the previously determined structure of the c(6 × 4) formed by coadsorption of Mg and Bi, and embedded MnBi₄ clusters are arranged in the top Cu layer instead of MgBi₄. Large lateral displacements of Bi atoms in the c(6 × 4)-(Mn + Bi) suggest that the Mn atoms undergo the size-enhancement caused by their large magnetic moment.     

Germanium growth on Br-terminated Si(1 0 0)

The consequences of Ge deposition on Br-terminated Si(1 0 0) were studied with scanning tunneling microscopy at ambient temperature after annealing at 650 K. One monolayer of Br was sufficient to prevent the formation of Ge huts beyond the critical thickness of 3 ML. This is possible because Br acts as a surfactant whose presence lowered the diffusivity of Ge adatoms. Hindered mobility was manifest at low coverage through the formation of short Ge chains. Further deposition resulted in the extension and connection of the Ge chains and gave rise to the buildup of incomplete layers. The deposition of 7 ML of Ge resulted in a rough surface characterized by irregularly shaped clusters. A short 800 K anneal desorbed the Br and allowed Ge atoms to reorganize into the more energetically favorable “hut” structures produced by conventional Ge overlayer growth on Si(1 0 0).     

冻干溶液的低温显微研究与热分析

利用低温显微系统研究了叔丁醇水溶液降温时的晶体形态,并利用差示扫描量热法(DSC)研究了溶液的反玻璃化结晶。低温显微实验表明:叔丁醇／水溶液结晶形状、大小与叔丁醇的浓度有关,浓度为10％时形成粗大的针状结晶, 有利于升华速率的提高。DSC实验表明:10％叔丁醇／10％蔗糖／水三元溶液的临界复温速率为250℃／min左右。